In my post yesterday I shared a photo of an On Board Bird Scrapbook that I recently created.
I would like to share some basic instructions on how I created the pages for this book.
STEP 1: Trace the chipboard bird onto the designer series paper of your choice.
NOTE: Trace on the back side of the pattern you would like to show & be sure to flip the bird in the opposite direction.
NOTE: Be sure to trace the hole at the top of the bird.
Cut along trace lines & punch hole with Stampin' Up!'s Crop-A-Dile.
Using Stampin' Up!'s Anywhere Glue Stick lightly coat the entire surface of the chipboard bird. Adhere the designer series paper to the chipboard bird lining up edges & punch hole.
Allow a few minutes for glue to set up and then sand, sponge & embellish as desired.
NOTE: If you are using ribbon as an embellishment, be sure to wrap ribbon ends behind designer series paper before adhering to the chipboard bird.
NOTE: Use Mini Glue Dots on back of ribbon to adhere to chipboard book.
Be sure to check back tomorrow to view the remaining page of my Bird Scrapbook.

Join Email List













