In my post yesterday I shared a photo of an On Board Bird Scrapbook that I recently created.
I would like to share some basic instructions on how I created the pages for this book.
STEP 1: Trace the chipboard bird onto the designer series paper of your choice.
NOTE: Trace on the back side of the pattern you would like to show & be sure to flip the bird in the opposite direction.
NOTE: Be sure to trace the hole at the top of the bird.
Cut along trace lines & punch hole with Stampin' Up!'s Crop-A-Dile.
Using Stampin' Up!'s Anywhere Glue Stick lightly coat the entire surface of the chipboard bird. Adhere the designer series paper to the chipboard bird lining up edges & punch hole.
Allow a few minutes for glue to set up and then sand, sponge & embellish as desired.
NOTE: If you are using ribbon as an embellishment, be sure to wrap ribbon ends behind designer series paper before adhering to the chipboard bird.
NOTE: Use Mini Glue Dots on back of ribbon to adhere to chipboard book.
Be sure to check back tomorrow to view the remaining page of my Bird Scrapbook.
